Cracked Opella Soap Pump? Try This Fix
An old Opella soap dispenser can be hard to repair.
The pump head may crack after years of daily use.
When that happens, the bottle may still look fine.
But the top may no longer push soap through the spout.
Many homeowners search online for an exact Opella replacement.
That search can be frustrating.
Older sink soap dispensers often have discontinued parts.
Some brands also used sizes that are not easy to match.
So the best fix may not be an exact Opella part.
A close-fit replacement pump may work instead.
Question
I have an old Opella soap dispenser with a cracked pump head.
Does anybody know if and where I can find a replacement?
I looked online and found nothing.
Answer
You may not find an exact Opella pump head today. Start by measuring the old pump. Then search for a universal soap dispenser pump head with the same neck size, tube size, and finish.
Remove the old pump from the dispenser first.
Most sink soap pumps pull straight up from the bottle or counter mount.
You can see a basic removal guide from Moen’s soap dispenser pump instructions.
Next, measure the threaded neck under the pump head.
Also measure the dip tube width and length.
Many replacement pumps are sold by neck size.
One common size is called 28/400.
You can compare examples at Home Depot.
You can also check Walmart replacement pump listings.
Look for stainless steel, chrome, brushed nickel, or plastic.
Match the finish as close as possible.
Do not buy only by looks.
The stem and tube must fit the bottle opening.
If the Opella bottle is built into the sink, measure carefully.
A bad fit can leak soap under the counter.
That can make a sticky mess inside the cabinet.
What If Nothing Fits?
If no pump fits, replace the full dispenser.
This is often faster and cheaper.
A new sink soap dispenser usually drops into the same counter hole.
Most use a simple nut under the sink.
Before buying, measure the sink hole and counter thickness.
Also check the bottle size under the sink.
Make sure there is room near the drain and supply lines.
Final Tip
Take the old pump to a local plumbing supply shop.
They may match it faster than an online search.
If they cannot match it, ask for a full dispenser kit.
That may be the cleanest repair.
I’m Chris Mayer, writing for Plumbing 101.
