A well pump problem can start as a small mystery. One day, the pump runs, but no water comes out. Then you shut the power off. You wait 20 to 30 seconds. After that, the pump starts working again. Pressure returns, and the tank climbs to 60 psi. At first, this may happen once a… Continue reading Well Pump Runs But No Water? Read This First
Tag: pump
Can Freezing Ruin Your Sump Pump?
Cold weather can be hard on any plumbing system. That includes your sump pump, sump pit, and discharge pipe. Many homeowners think an unplugged pump is safe. That is not always true. Question: Can a sump pump still be damaged if it is unplugged? Answer: Yes. If water freezes inside the pump, pipe, or pit,… Continue reading Can Freezing Ruin Your Sump Pump?
Why Is My Shallow Well Pump Thumping?
A thumping shallow well pump can be hard to track down. The noise may sound like a steady thump near the shutoff. In this setup, a new Acquaer 1 HP shallow well pump feeds a home. The water comes from a 1,200-gallon RO holding tank. The tank sits about five feet from the pump. The… Continue reading Why Is My Shallow Well Pump Thumping?
NaviCirc Setup: Do You Need an Extra Pump?
You have a Navien tankless water heater. You want to add a NaviCirc recirculation valve. You also want faster hot water at the tap. Your home is new and single-level. It is about 100 feet from end to end. The heater is about 30 feet from one end. The kitchen and laundry sit near the… Continue reading NaviCirc Setup: Do You Need an Extra Pump?
Gauge Hits 100 After Pump Stops? Here’s Why
You run a 40/60 pressure switch. Your tank precharge is set to 38 PSI. The pump cycles as it should. After the shutoff, the gauge creeps toward 100 PSI. You replaced the switch and the gauge. The strange climb still happens. Quick Q&A Q: Is my water pressure really climbing to 100 PSI? A: It… Continue reading Gauge Hits 100 After Pump Stops? Here’s Why