Why Is My Sewage Pump Running After Rain? A finished basement can add comfort and value to a home. But it also adds plumbing parts that need care. One common part is a sewage ejector pump. This pump moves wastewater from the basement fixtures up to the main sewer line. It should only run when… Continue reading Why Is My Sewage Pump Running After Rain?
Tag: after
No Hot Water After Bathroom Remodel?
No Hot Water After Bathroom Remodel? A bathroom remodel can uncover plumbing issues fast. One common problem is losing hot water after the water is turned back on. This can be confusing when no leaks appear. You may get warm water for a short time. Then the shower and house fixtures stop getting hot water.… Continue reading No Hot Water After Bathroom Remodel?
Old Cast Iron Hub Leak Returns After 35 Years
Some plumbing problems never fully go away. They may stay quiet for decades. Then one day, a soft floor or stained wall brings them back. That seems to be the case in this old 1910 home. The owners bought the house nearly 40 years ago. A few years later, they gutted the upstairs bathroom. During… Continue reading Old Cast Iron Hub Leak Returns After 35 Years
Why Pipes Thump After Sprinkler Startup
Did your pipes start thumping after your sprinkler system was turned on? That sound can be scary. It may sound like a faraway helicopter. It may happen after flushing a toilet. It may also start after using a sink, shower, or hose. In this case, the timing matters. The noise started right after the lawn… Continue reading Why Pipes Thump After Sprinkler Startup
Septic Gas After Pumping? Check This Vent
A septic gas smell after pumping can be scary. It can feel worse when the smell reaches a bedroom. That is even more serious when a child sleeps nearby. In this case, the smell showed up after a shower. The home had a three-chamber septic tank with a lift station. The tank had been pumped… Continue reading Septic Gas After Pumping? Check This Vent
Gauge Hits 100 After Pump Stops? Here’s Why
You run a 40/60 pressure switch. Your tank precharge is set to 38 PSI. The pump cycles as it should. After the shutoff, the gauge creeps toward 100 PSI. You replaced the switch and the gauge. The strange climb still happens. Quick Q&A Q: Is my water pressure really climbing to 100 PSI? A: It… Continue reading Gauge Hits 100 After Pump Stops? Here’s Why
Hot Water Smells Like Oil After New Heater?
You paid for a brand-new Bradford White water heater. It was recommended by your plumber. Two workers installed it. The unit also needed a fuel conversion. It went from propane to natural gas. Right after the install, the hot water smelled like oil. The smell is now faint. But it is still there. That can… Continue reading Hot Water Smells Like Oil After New Heater?